1. Before installing the cantilever crane, preparations must be made.
Check whether the product and technical documents are missing or lost according to the packing list. If the jib beam is bent, twisted, deformed or bruised during transportation, it should be corrected or restored respectively. After checking that the shipped product is correct, proceed with installation.
2. Column installation
When installing the columns, the columns should be kept vertical to the ground, and the screws on the baseboards should be tightened firmly without loosening. The base plate and foundation should fit well. If an electric hoist is equipped, the foundation should have pre-embedded cables and grounding facilities. The pre-embedded cables should be led out from the center of the foundation, and the grounding resistance should not be greater than 4Ω.
3. Installation of cantilever beam
To install the cantilever beam, please proceed in the following order.
1) First lift the beam horizontally.
2) Connect the slewing device to the swivel arm beam. Install the reducer.
3) Install the electric hoist and traveling trolley on the jib beam track.
4) The fourth step is to install the sliding contact wire frame and steel wire rope or C-shaped track on the top of the cantilever beam. The rope is stringed into the sliding ring and tightened. There is a small pulley in the track, and it should be placed at the same time as the electrical control box on the electric hoist. On one side.
5) Connect and install all electrical appliances on the beam, leaving a power cord of appropriate length. (See the electrical schematic diagram and electrical wiring diagram for wiring).
After the above steps are completed, the overall hoisting of the cantilever beam can be carried out.
4. Cantilever lifting
When hoisting, after lifting according to the specified lifting method, align the shaft with the bearing hole on the top of the column, and slowly lower the roller against the raceway of the column. After adjusting the appropriate position, use washers, round nuts and round nut stop washers to fix the shaft through the side holes on the upper part of the column. Then drag the collector ring with one hand, pass it through the side hole on the upper part of the column, and put it on the beam shaft.
Then, connect the wires hanging in the peripheral holes of the beam to the terminals on the collector ring, connect the carbon brushes to the power switch at the bottom of the column with wires, and finally fix the carbon brush holder on the inner wall of the column. Adjust the sliding piece to maintain good contact with the copper ring on the collector ring. Turn on the power and you can test drive.
Precautions:
1. When installing collector rings and other components in the column, necessary measures (such as tying them with ropes in advance) should be taken to prevent them from accidentally falling into the column.
2. If this machine is installed and used outdoors, reliable rainproof measures must be installed.
After assembling the cantilever beam and column, it should be done
①The rollers and raceways should fit well.
②The rotating arm can flexibly rotate 360° around the column.
③Adjust the adjusting gasket so that the end of the swing arm beam reaches the upper deflection F ≥ R/250 (R is the radius of rotation).
